本文へ移動

Molding

Molding of MEIKODO

Marking pin
From around 1965, we decided to make pearl waiting needles, which will become our main product, and resin molding of Meikodo began.
Initially, it was a simple spherical molded product, but over the years, we have worked on a wide variety of products, and as a result, various technologies such as thin-wall molding and twice molding have accumulated, and now products that are active in various fields are Producing.
When launching a new product, we design the mold in-house and develop a product that meets your requirements in a short time.

Insert molding

Insert molding
Meikodo specializes in making insert molded products that incorporate a wire material into a resin like a push pin.
Cost reduction and quality control can be performed appropriately because the products are manufactured in-house consistently.
Among the main products, we also manufacture cosmetic accessories such as brushes and combs.

Pad print

Pad print
Transfer the ink to the silicone pad and press it onto the product like a stamp to print. Utilizing the elasticity of the silicone pad, it is possible to print not only on flat surfaces but also on curved and uneven surfaces.
It is possible to print original logos and designs on molded products to develop original products.
Meikodo Co., Ltd.
〒735-8555
4-1-36, Osu, Fuchu-cho, Aki-gun, Hiroshima, Japan
TEL.+81-82-581-2400
FAX.+81-82-581-2406
TOPへ戻る